Frigomat PEB 30 Manual De Uso Y Mantenimiento página 55

6.7 DRAWING OF THE PRODUCT FROM THE TANK
To extract the product in the tank, proceed as
follows:
- If the product has been in storage for more than
2 hours, before starting the drawing press the
"MIXER" key to turn on the agitator motor. Let the
agitator turn for a few seconds to ensure that the
entire mass of product in the tank is well mixed
and not separated. It is possible to stop the
manual mixing at any time by pressing again the
"MIXER" key.
- Move the transparent drip cup from its collecting
position and place a container of adequate
capacity by the tap.
- Turn slowly the knob of the dispensing tap anti-
clockwise to begin the drawing of the product.
- After delivery, close the water tap by pushing the
knob to the front panel of the machine.
- Press the "WASH TAP" to rinse the tap
Always remember to perform the washing of the
tap after each supply as the permanence of
residual product in the faucet for long periods can
generate the formation of undesired bacteria
ENGLISH - 22