Frigomat PEB 30 Manual De Uso Y Mantenimiento página 57

• Pour the maximum admitted load of cold drinking
water into the tank to rinse the surfaces which were
just treated with the sanitizer.
• Drain the rinse water and turn the machine off.
• When pre-washing is over, all the removable parts in
contact with the product must be disassembled and
sanitised in a separate tank.
SANITISING REMOVABLE PARTS
PREPARATION OF WASHING TANK
• Wash your hands well and wear disposable gloves.
• Fill a clean tank with a sufficient amount of drinking
water at approximately 50°C and the sanitizer.
• Prepare the supplied brush and the OR disassembly
device and emerge them in the solution.
REMOVING AND CLEANING COVER
• Pull the hinge pins off and remove the cover, holding
it with both hands.
• Emerge the previously disassembled components
into the tank with the sanitizer and brush the
surfaces with care. Pay special attention to the
surfaces in direct contact with the product.
REMOVING AND CLEANING BEATER
• Pull the beater upwards to pull it out of the tank.
• Remove the top cap.
• Remove the MIXING reduction disc, if present, by
pulling it upwards. Remove the OR.
• Turn the plastic impeller clockwise until it releases.
ENGLISH - 24