Publicidad
Idiomas disponibles
Idiomas disponibles
WATER HARDNESS: Remains lit during
the definition of the water hardness.
SHORTAGE OF WATER: Remains lit when
the water tank needs topping up.
WARNING
The sensitivity of the touch keys adapts
continually to environmental conditions.
Make sure the surface of the control panel is
clean and free of obstacles when plugging
in the oven.
If the clock does not respond correctly when
you touch the keys, unplug the oven for a
few seconds and then plug it in again. Doing
this causes the sensors to adjust automati-
cally so that they will react once more to fin-
gertip control.
SHOWROOM MODE
With the DEMO mode activated, you can con-
trol the oven without heating. This mode must
be activated before setting the time on the
clock if it is to be installed in an exhibition with a
mains power connection.
Activating DEMO mode
Press the buttons
on the programing mode, until SHO appears on
the screen.
Then, set the time on the oven.
The letters SHO are displayed for a few sec-
onds every minute to indicate the state of the
appliance.
The oven can be used as normal but it will not
heat up.
To switch off the DEMO Mode, disconnect the
appliance from the mains power supply.
and
simultaneously
SETTING THE TIME
• To set the time on the oven, the function and
temperature dials must be in the
• When you plug in the oven, you will see the
clock flashing 12:00.
• Touch
or
then the minutes. You will hear a double
beep confirming the time is set.
• If you wish to modify the time, touch
until the time starts flashing. Touch
and and follow the instructions in the previ-
ous point.
NOTE
The clock light has a night mode so the display
light will dim between 00:00 and 6:00 hours.
WARNING
In the event of a power failure, your elec-
tronic clock/timer settings will be erased.
If this happens, turn the function and tem-
perature dials to the
The indication 12:00 will show, and you will
then be able to set the time as described
above.
WATER HARDNESS
• After setting the clock, you need to set the
water hardness.
• The Water Hardness option appears on the
display.
• To change the option rotate the right control.
• Press
to confirm the option.
• To modify the water hardness, touch
until the function symbol
• Press
to confirm the option.
english
position.
to adjust the hours and
position.
flashes.
User's Guide
or
or
29
Publicidad
