Vortice SOFT DRY Manual De Instrucciones página 11

Impaginato 025 19-12-2003
CAUTION
!
Caution:
• Do not make modifications of any kind to this
appliance.
• Do not expose this appliance to the weather (rain,
sun, etc.).
• Do not obstruct the air nozzle.
• Do not fit any accessory other than those supplied
to the air nozzle.
• Always replace the air nozzle when you finish using
it.
• Always hold the grip to use the appliance. Avoid
squeezing the hose. This will restrict the air flow.
• Do not insert any objects through the nozzle into
the flexible hose.
• Do not place lit cigarettes on the appliance.
• Do not stub out cigarettes on the cover of the
appliance.
• Regularly inspect the appliance for visible defects. If
any faults are found, do not operate the appliance
but contact Vortice* immediately.
• If the appliance does not function correctly or
develops a fault, contact Vortice* immediately and
ensure that only original Vortice spares are used for
any repairs.
• Should the appliance be dropped or suffer a heavy
blow, have it checked by Vortice* immediately.
• This appliance must be installed by a professionally
qualified electrician.
• Install the appliance vertically in accordance with
these instructions. Install the appliance with the air
outlet from the body facing downwards.
• Make sure that the wall on which the appliance is
installed is perfectly vertical.
(* Or an authorised Service Centre if you are outside the UK-Ireland territory)
!
Do not pull on the flexible hose.
15:46 Pagina 11
this symbol indicates precautions that must be taken to avoid damaging the appliance.
• Ensure that the electrical system to which the
appliance is connected conforms to applicable
standards.
• The appliance is double insulated and therefore
does not need to be earthed.
• The electrical power supply/socket to which the
appliance is to be connected must be able to
provide the maximum electrical power required by
the appliance. If it cannot do so, arrange for a
professionally qualified electrician to make the
necessary modifications.
• Use a multi-polar switch with minimum contact gaps
of 3 mm to install the appliance.
• If you are installing the appliance in a public
building, install a thermal cutout or earth leakage
detector in series with the main switch.
• Switch off the appliance at the installation's main
switch: a) if the appliance does not function
correctly; b) before cleaning the outside of the
appliance; c) if the appliance is not to be used for
any length of time.
• If the appliance gets too hot, a special cutout trips
to protect the heating element. This device resets
automatically. If this safety device trips, you must
wait for the appliance to cool down again before
you can restart it (about 1 minute). This temporary
interruption of hot air delivery is not the result of a
fault, and represents improved safety for the user.
• If power loads in excess of 10 W are connected to
the power sockets, an automatic safety device
disconnects power. You must wait for power to be
restored before you can start using the power
sockets again.
EN
11