Publicidad
Idiomas disponibles
Idiomas disponibles
(marked field on the dipstick), which we check on the dipstick of the
cap after it is fixed in the hole.
It is recommended to keep the level closer to the upper than the lower
•
acceptable limit. In case of overflowing beyond the permissible level,
excess oil can be sucked out through the plug hole.
ATTENTION: operating the engine with the wrong oil level can lead to
engine damage! Check the engine oil level before each machine
operation when the engine is still cold.
REFUELING
ATTENTION: The engine of the device is adapted only to burn unleaded gasoline
without oil admixtures. The use of other fuel that is not fresh and with too high an
ethanol content or of low quality can lead to engine failure. Refuel only with the
engine off, paying close attention not to spill fuel over the engine, especially when
it is hot - risk of fire! If the engine is warmed up, wait at least 2 minutes before
refueling.
•
Place the machine on a level, horizontal surface.
The fuel tank is located on the top of the unit.
•
•
Unscrew the fuel filler cap (with the dispenser icon). Do not pull out
the strainer filter inside the opening!
•
Refill fuel through the plug opening - the maximum fuel level in the
tank should not exceed the upper limit of the red level gauge in the
strainer filter, i.a. reach the bottom of the filler neck as max.
3.3.
Working with the device
3.3.1 Startup
•
Set the fuel valve - distributor icon - to the open position ("OPEN" - see
the signature pictogram on the air filter housing) so that fuel can flow from
the tank to the carburetor to start the engine.
Publicidad
