hillvert HT-HECTOR-100B Manual De Instrucciones página 41

NOTE: starting a warmed-up engine does not require switching on the
suction - its lever should be in the open position.
IMPORTANT: low speed is only for idling the engine - use the highest
speed when operating the machine.
3.3.2 Stopping
• Set the slowest engine speed with the throttle lever (move it towards the
turtle icon) and let the engine run at low speed for 1-2 minutes to cool it
down a bit.
Turn off the ignition by setting its switch to the "OFF" position.
•
Alternatively, you can close the fuel valve (switch to the "CLOSE" position)
and wait for the engine to stop - this method will get rid of residual fuel
from the carburetor, so it is worth using it before storing an unused
machine for a long time.
ATTENTION: if you need to stop the device suddenly, press the emergency
stop button but use this method only in an emergency!
IMPORTANT: never use the choke lever to stop the engine by throttling
it!
• If the machine will not be used any further, then close the fuel supply valve
- set its lever to the closed ("CLOSE") position.
3.3.3 Work
Top view:
• The "OK" box checked is the operator's default safe area when working
with the machine relative to the given hopper - of course, the position
may differ depending on the hopper used! The arrows indicate the
direction (area) of material processing in the machine.