Rohde ST 410 Instrucciones De Uso página 45

14. Cleaning the control unit .......................................................................................................................... 78
14.1. General safety note .................................................................................................................................. 79
14.2. Cleaning instructions ................................................................................................................................ 79
15. Disposal of the control unit ....................................................................................................................... 79
16. Additional Information .............................................................................................................................. 79
16.1. Warranty provisions ................................................................................................................................. 79
16.2. Property rights / Brand names / Disclaimer .............................................................................................. 79
17. Declaration of Conformity ......................................................................................................................... 80
1. Introduction
1.1. Preface
You have chosen an ST 410/ST 411 controller, a high-quality product for your kiln. This controller series incorporates
the latest technological features, is being continuously developed and is the leader in its class.
After reading this instruction manual, you will be familiar with the functionality of the ST 410/ST 411 controller.
Please make sure that you fully understand the kiln manufacturer's safety instructions. Make sure that the control unit is
mounted at a safe distance from the kiln and is not exposed to direct heat from the kiln. Do not place the control unit
on top of the kiln.
The images shown in this instruction manual illustrate the functions and may differ in some ways from the actual
product.
1.2. Scope of delivery
No. Part
1 ST 410 or ST 411 control unit
Control unit bracket
2
3 Mounting material for bracket
4 USB flash drive
5 Instruction Manual
Remark
Type varies depending on the version
For attachment to the kiln or wall
For attachment to the kiln or wall
Data transfer of recorded measured values
43 / 291 - EN -