Publicidad
Idiomas disponibles
Idiomas disponibles
14.1. General safety note
CAUTION
The control unit and the kiln must not be hosed down with water jets, hoses or
high-pressure cleaners for cleaning.
14.2. Cleaning instructions
Remove contamination with a clean, dry cloth.
Do not use detergents.
Never spray the control systems with a water jet or high-pressure cleaner.
Never use compressed air.
15. Disposal of the control unit
The control unit must be properly disposed of at the end of its service life.
Electrical equipment must never be disposed of with general or household waste.
This must be collected separately for proper disposal. In this way, you help with the
recovery, recycling and reuse of raw materials.
To protect the environment, components and packaging that are easy to dispose of are
predominantly used.
16. Additional Information
16.1. Warranty provisions
We guarantee the perfect workmanship and function of the delivered control unit and usually grant a 36-month
warranty from the invoice date (except wear parts).
For exceptions to the warranty period, please refer to the invoice for the control unit.
In addition to wearing parts, the following items are excluded from the warranty:
Fuses (wear part)
Damage caused by the customer.
Damage from heat and warmth because the control system was placed on the kiln.
Damage due to improper handling.
Subsequent modifications or changes to the control system that have not been authorised or approved in writing
by the manufacturer.
Exclusion of any liability on the part of the manufacturer in the event of improper handling and resulting damage.
16.2. Property rights / Brand names / Disclaimer
There may be deviations in the content of this instruction manual, which are due to technical changes. The information
in this instruction manual is checked regularly; necessary corrections are included in the subsequent editions. This
instruction manual is not subject to the automatic update service. Common names, trade names, product descriptions
etc. are reproduced in this instruction manual without special identification, as these are generally known. However,
these names and designations could be the property of companies or institutes.
The possible consequences are:
Damage to components,
Impairment of functions
Failure of control system and kiln
Always clean the control unit and kiln dry.
Do not use water or compressed air for cleaning.
79 / 291 - EN -
Publicidad
