Rohde ST 410 Instrucciones De Uso página 49

Attention!
If the contactors are not suppressed by a varistor, the controller can be damaged.
3. Safety instructions
Adhere to all safety and warning instructions for the control unit and observe the operating instructions and the
information on the warning signs for the kiln to which the control unit is connected.
 Keep the instruction manuals for the control system and the kiln so
• that they are always accessible to everybody who works on the kiln and
• that they are always close to the kiln.
DANGER
Disregarding this instruction manual can lead to serious personal injury, property damage
and even death.
 Please make sure that you fully understand this instruction manual.
 Only use the control unit if it is in technically perfect condition!
 Observe the operating instructions for the kiln to which the control unit is to be connected.
 Please make sure that you fully understand the kiln manufacturer's safety instructions.
DANGER
Working with an improperly connected control unit and kiln or an electrically defective
control unit and kiln can lead to serious personal injury, property damage and even death.
 Check the kiln and the control unit regularly to ensure that they are in proper and perfect
 Have the kiln checked regularly (at least once a year) to ensure it is in perfect working
 Only have the tests carried out by a qualified electrician.
 In the event of damage or defects, do not put the control unit or kiln into operation or shut
DANGER
Disconnect the kiln and control unit from the power supply before attempting installation or
repair work.
 Risk of severe personal injury, property damage and even death.
WARNING
An incorrectly placed control unit can lead to serious personal injury or property damage.
 The control unit should never be placed on the kiln but should only be positioned in the
WARNING
An incorrectly connected control unit can lead to serious personal injury or property
damage.
 Please make sure that you follow the specifications in this instruction manual and the
 Make sure that only a properly connected control unit is put into operation.
condition before using the equipment for the first time and during operation.
condition.
down both immediately.
bracket provided for it.
operating instructions for the kiln.
47 / 291 - EN -