Rohde ST 410 Instrucciones De Uso página 63

Display
00.00
 The firing process can be started by pressing the
"Program running" indicator continues to signal that a firing is in progress.
 For technical reasons, there is a point between the hours and minutes in the display and not a "colon" as is
usual with times.
Note:
The program delay for the delayed start for each firing process is set to "00.00" in the factory.
8.1.4. Program advance function
• While firing press and hold down the
• The controller will emit a short beep and immediately advances the program by one step.
• The process is indicated accordingly in the course of the program on the graphical display by a flashing icon.
• The effect of this is as follows:
If ramping, then the controller will switch to soak at the current kiln temperature.
­
If soaking, then the controller will advance to the next segment if any, or else it will end the firing.
­
• Changes made to the operation of the controller in this way are temporary and are not stored.
8.1.5. Program pause facility
General safety note:
WARNING
Risk of serious damage to property due to too long a soak time when using the program
pause function.
 If left too long at high temperatures, kiln damage could result.
 The program pause function causes the program to pause but the temperature is still
 Leaving the ware too long at high temperatures could damage it or have a negative
Operation:
Step
Activating the program
pause facility
Ending program pause
Icon Description
While the firing indicator light is flashing on the display, a program start delay
of up to "99 hours:59 minutes" can be entered using the
d
key for 3 seconds to obtain the program advance function.
maintained!
impact on the firing results.
Description
The program pause facility is
activated by pressing the
The program pause is ended by
f
pressing the key.
61 / 291 - EN -
j
key again or will do so automatically after 5 seconds. The
Remark
The controller sounds a short beep, the current
program is paused and the current kiln
f
key.
temperature is maintained.
The paused firing program continues.
d f
and keys.