Rohde ST 410 Instrucciones De Uso página 66

8.3.5. Adjusting the firing values during firing
During the program, certain firing values can be changed using the controller:
g
Use the key to select the desired parameter during the firing process.

The parameter is indicated accordingly in the course of the program on the graphical display by a flashing icon.

The firing value is shown on the main display and can be adjusted with the

The contents of the current segment or any segment still to be executed can be changed.

Firing will still carry on as normal while these changes are being made.

The controller will return to its normal running display 20 seconds after key presses cease (or immediately after

"END" is displayed).
Changes made to programs in this way are stored and are used for subsequent firings.

8.4. "Hysteresis" regulation for photovoltaic systems (ST 411 only)
The ST 411 control system is factory-set to control a kiln that is provided with electrical energy from a central power
supply (PID). If electrical energy is provided at the installation site by a photovoltaic/PV system to operate the kiln, the
factory control (PID) may not be adequate. It might be useful to configure the optional "hysteresis" regulation for
photovoltaic/PV systems in the ST 411 controller. Especially, this is true if the photovoltaic/PV system is also equipped
with a storage battery (electricity storage/battery storage).
If you use a photovoltaic/PV system to operate your kiln and would like advice on the optimal control behavior of the ST
411 control system, please contact the manufacturer.
The optional "hysteresis" regulation for photovoltaic/PV systems can be configured without replacing the ST 411
control system, but the device may have to be sent to the manufacturer for configuration or a service appointment may
be necessary on site.
9. Error messages
9.1. General description
If the control unit detects a problem, the buzzer will sound, and an error message will be displayed.
9.2. Display screen
Display Description
Main display This error message will alternate with a display of the kiln temperature.
Segment display Displays the respective segment number where the error may have occurred.
9.3. Reading error messages
Step Activity
h
1
Press the key to obtain more information on the error.
h
Press the key again to display the length of time the
2
error has been present.
Remark
The first press will display the maximum
temperature reached in the firing.
The buzzer will mute.
64 / 291 - EN -
d f
and keys in the usual way.