Rohde ST 410 Instrucciones De Uso página 50

NOTE
Do not open the device cover.
 There are no user-serviceable parts inside.
4. Mounting
4.1. General safety note
WARNING
An incorrectly placed control unit can lead to serious personal injury or property damage.
 The control unit should never be placed on the kiln but should only be positioned in the
4.2. Mounting the bracket
 The control unit comes with a suitable mounting bracket which can be
attached to the kiln or at the operation location (near the kiln or on a wall).
 The bracket is attached with 2 screws.
 Note the direction of the arrow while the bracket is being installed
(arrow direction = up).
 Never place the control unit on the kiln but use the bracket instead.
 When mounting on the kiln, the bracket is mounted on a suitable controller
mounting plate or the switch box.
 Please refer to the operating instructions for the kiln.
 When mounting on a wall, the bracket is screwed directly to a wall near the
kiln using the fastening material supplied.
 The appropriate mounting material is included in the scope of delivery.
4.3. Connecting the connection cable
Step Description
1 Insert the plug of the control unit into the socket on the kiln.
The plug and socket have a geometric coding – the plug and socket only fit
2
together in one position.
The wide lug on the plug must be at the top in the 12 o'clock position to fit
3
into the wide recess on the plug, also in the 12 o'clock position.
4 You may have to twist the plug a little until it clicks completely into the socket.
5 Tighten the outer screw ring on the plug clockwise.
bracket provided for it.
48 / 291 - EN -
View on plug