Worn-Out Of The Knife Holder Face; Setting The Material Thickness Of The Cloth Cutting Knife - JUKI MEB-3200 Manual De Instrucciones

(3) Worn-out of the knife holder face

Contact face of the knife holder with the
cloth cutting knife.
A
B
1. When replacing the knife, use a new knife holder or a corrected knife holder.
Breakage of the blade tip of the cloth cutting knife may occur.
2. When correcting the knife holder, adjust again the knife pressing amount.
3. When replacing the knife holder with a new one, adjust again the knife pressing amount from 30 or less.

(4) Setting the material thickness of the cloth cutting knife

When the material thickness at the cloth cutting section is excessively thick or the cut length of
heavy-weight materials is long, perform the following settings. The low-speed section of the cloth
cutting is increased.
1) Turn ON the memory swtch.
2) Set the memory swtch No. 57 or 58 to the value A or B descrbed n the table below.
Standard value (Up to jeans)
A (Extra heavy-weght materals)
B (Extra heavy-weght materals and long cut length)
• When the set value A or B is selected, the cloth cutting knife operating time is lengthened.
• When the set value is smaller than the standard one, the normal cloth cutting operation may not
be performed.

1) Remove the knfe holder. (See p.26.)
2) When the knfe mark s too deep, the knfe mark
C
3) When the cloth cannot be precsely cut although
Can be corrected
up to 2 mm.
s duplcate (A of Fg. on the left sde) by usng
another knfe or the knfe mark s partally formed
and not formed on the whole surface (B of Fg. on
the left sde), grnd the face wth an ol stone or
the lke so that the knfe mark becomes unform.
The knife holder can be corrected up to 2 mm.
the knfe holder s properly corrected, check the
state of worn-out of the blade tp of the cloth
cuttng knfe.
No.57 No.58
60 80
100 100
150 120