Setting The Reduction Speed Of Eyelet; Setting The Function F1; Setting The Function F2 - JUKI MEB-3200 Manual De Instrucciones

(12) Setting the reduction speed of eyelet

1

(13) Setting the FUNCTION F1

1
－
＋

(14) Setting the FUNCTION F2

The pattern data located in the copy destination are overwritten. So, be careful.
When the pattern No. is changed without pressing [READY
is not performed.
This key can be changed to the key for setting other data by means of the memory switch No. 18.
(Refer to "14. MEMORY SWITCH" p.68.)
2
2
1 2
Set the reduction speed when the sewing speed
of eyelet section is desired to be reduced.
Set the reducton speed wth [RIGHT
[RIGHT ] key 2 .
The speed can be set − 600 st/mn to 0 st/mn n
the ncrements of 100 st/mn.
• F1 has been set to the switch of knife position
compensation in the state of delivery.
• F1 performs correction of the slip between
the knife position and the sewing position.
1) When the sttches n terms of the knfe poston are
desred to be placed n the front sde, set " ＋ " (plus)
value, and n the rear sde, set " − " (mnus) value.
2) Set the pattern No. wth [RIGHT
[RIGHT ] key 2 .
The knfe poston compensaton can be set − 0.7
mm to 0.7 mm n the ncrements of 0.1 mm.
This key can be changed to the key for
setting other data by means of the memory
switch No. 17.
(Refer to "14. MEMORY SWITCH" p.68.)
• F2 has been set to the switch of the copy
destination No. in the state of delivery.
• F2 performs copying of the pattern data.
1) When settng the copy destnaton No. and pressng
[READY ] key, the pattern No. specified in the
copy destnaton No. s stored n memory.
The orgnal pattern data cannot be changed.
2) Set the pattern No. wth [RIGHT
[RIGHT ] key 2 .
The No. can be set 1 to 89.
] key, or turning OFF the power, copying
] key 1 or
] key 1 or
] key 1 or