Compensation Of The Data; Knife Position Compensation; Number Of Stitches Of Sewing End Compensation - JUKI MEB-3200 Manual De Instrucciones

9. COMPENSATION OF THE DATA

6
7
8
2
3
1
The data No. is stated in 2-digit LED 8 and the example of the set value is stated in 4-digit LED 9 as
shown below. The setting range is stated in the respective sentences.
S t i t c h e s o f t h e r e s p e c t i v e
compensations as shown below
are expreseed by the stitches as
observed from the right side of
stitching.

(1) Knife position compensation

1

(2) Number of stitches of sewing end compensation

1
1) Confirm that sewing LED 7 has gone out.
9
2) Dsplay the pattern No. desred to be changed.
3) Press [DATA
4) Press [LEFT
5
5) Press [RIGHT
4
6) Press [READY
7) When the memory swtch No. 20 s equal to
Wrong side
of stitching
＋
−
2
−
2
＋
When the LED lghts up, press [READY
to make t go out.
] key 1 to dsplay the data.
] key 2 or [LEFT
dsplay the data No. of the part desred to be
changed.
] key 4 or [RIGHT
re-set the respectve data.
] key 6 to lght up sewng LED
7 and the data are stored n memory.
When changing the pattern No. without
pressing [READY
the power, the data are not stored in memory.
It is necessary to set again the data.
"1", change of settng the data n step 5) can be
prohbted.
Right side
of stitching
Correct the slip between the position of
knife and sewing position.
1) When the knfe poston n terms of the sttches
s desred to be placed n the rear sde, set " ＋ "
(plus) value, and n the front sde, set " − "
(mnus) value.
2) Set the knfe poston wth [RIGHT
[RIGHT ] key 2 . Settng can be performed −
0.7 to 0.7 mm n the ncrements of 0.1 mm.
Number of stitches of sewing end can be
increased at the same sewing pitch.
Set the number of sttches wth [RIGHT
or [RIGHT ] key 2 .
Settng can be performed as follows :
Wthout bartack ...
Taper bar
Straght bar
] key 6
] key 3 to
] key 5 and
] key 6 or turning OFF
] key 1 or
] key 1
1 to 6 sttches
−
... 1 to 6 sttches
−
... 1 to 3 sttches
−