Installing The Thread Stand; Installing The Operation Panel Base - JUKI MEB-3200 Manual De Instrucciones

(3) Installing the thread stand

1
2

(4) Installing the operation panel base

5) The sewng machne stops once more at the
final stage of lowering for the safety. Support the
perphery rbs of machne bed wth your left hand,
hold the grp of hnge stopper secton wth your
rght hand to release the lock and slowly lower the
sewng machne followng the descrpton of step 3).
1) Assemble thread stand unt 2 .
2) Insert t n the hole located n the rear of the
machne table, and tghten locknut 1 to fx the
thread stand.
Fx operaton panel base 1 at the dottng punch
secton on the machne table wth wood screw 2 .
1
2
DANGER :
Take care to prevent pinching of hands and
fingers between the sewing machine and the
bottom cover. In particular, never lower the
sewing machine holding parts other than
the bed rib with two or more workers, since
doing so can cause pinching of hands,
fingers and arms leading to a serious injury.
When the ceiling wiring is possible, pass
the power cord through the spool rest rod.
Protection vinyl is coated on the surface of
the operation panel. Remove it.