How To Take Out The Sewing Products When The Thread Cutting Failure Has Occured (For Z Type Only) - JUKI LK-1941 Manual De Instrucciones

20130424 LK-1941,1942 R08
4. How to take out the sewing products when the thread cutting
failure has occured (for Z type only)
Thread is cut and the sewing product can be taken out by reheating the hot wire plate when needle thread
or bobbin thread is not cut at the time of completion of sewing.
A
Thread is not cut even when the hot wire plate is reheated according to the cause of
thread cutting failure.
1) Pull the sewing product in the direction of A and
take the slack of the thread in the state of
completion of sewing (state that the sewing LED is
lit up and the feeding frame is raised).
2) When the temporary stop switch is pressed, the
hot wire plate is heated and the thread is cut.
Once the operation is performed, re-
operation cannot be performed for
five seconds.
37