Using An Ac Power Adapter; Tube Connection - Microlife Advanced Manual De Instruccion

MLUBPT0-AP-APC-MAR06-1
Attention!
• After the low battery indicator appears, the device won't function until the batteries
have been replaced.
• Please use "AA" Long-Life or Alkaline 1.5V Batteries.
• Do not use rechargeable batteries.
• If the blood pressure monitor is not used for long periods, remove the batteries from
the device.
Functional check: Hold the On/Off button down to test all the display elements. When
functioning correctly many icons will appear.

4.2. Using an AC power adapter

It is possible to operate this blood pressure instrument with an AC adapter. (output 6 V DC
/ 600 mA with DIN plug). Make certain that you use an adapter which fulfills the legal
requirements and electronic requirements in the U.S. (UL standard). Use of an AC adapter
other than a Microlife adapter may invalidate your warranty.
a) Push the plug into the socket at the left side
of the instrument.
b) Plug the AC adapter into a 110 V
power socket (U.S. or Canada).
c) Test that power is available by
pressing the On/Off button.
Note:
• No power is taken from the batteries while the AC adapter is connected to the instru-
ment.
• If the power is interrupted during a measurement (e.g. by removal of the adapter from
the wall socket), the instrument must be reset by removing the plug from the instru-
ment.
• Please call 1-800-568-4147 if you have questions
relating to the AC adapter.

4.3. Tube connection

Insert the cuff tube into the opening
provided on the side of the instrument,
as shown in the diagram.
7
4/5/06 9:36 AM
(special accessory/included with Model #3BT0-APC)
Left Opening
Right Opening
Page 8