Publicidad
en | 14 | SCT 815 S5/S6
1.5
Safety Notes
WARNING
Severe eye damage from laser beam. Death or
severe injury.
Never look directly into the laser source.
Never point the laser beam at people, particu‐
larly at their faces or eyes.
To test function, hold an object in front of the
exit point of the laser range finder and line la‐
ser.
---Separator---
CAUTION
Risk of injury from objects falling from the
SCT 815 S5/S6. Minor injury.
Wear safety shoes.
Always use the arrestor cable to secure the line
laser.
---Separator---
CAUTION
Risk of crushing when adjusting the height of
the prismatic reflector. Minor injury.
While the height of the prismatic reflector is
being adjusted, do not place fingers between
the tool holder and the guide tubes.
---Separator---
1.6
Other applicable documents
The brief instructions (one-pager) can be found
in the Bosch Media Library:
loads.bosch-automotive.com
---
• 1 690 386 038 – P-Assist original instructions
• 1 609 92A 7PV – GLM 100-25 C original instructions
• 1 689 989 363 – Honda brief instructions
• 1 689 989 364 – Toyota brief instructions
• 1 689 989 365 – Mazda brief instructions
• 1 689 989 366 – Kia brief instructions
• 1 689 989 367 – Hyundai brief instructions
---
2.
Product description
---
2.1
Intended use
SCT 815 S5/S6 is an adjustment device for calibrating
the front radar sensor by the following vehicle manu‐
facturers:
• Mazda
• Honda
• Toyota
• KIA
• Hyundai
In conjunction with diagnostic software, the front radar
sensor can be calibrated for the ACC (adaptive cruise
control) and the emergency braking assistance.
Any other use is considered improper use and is
not permissible.
---
2.2
Scope of delivery
Denomination
Base plate
1 689 989 475 | 2023-06-28
Denomination
Guide tubes
Line laser mount
Tool holder for prismatic reflector
3 plastic screws
Prismatic reflector
Mount for laser range finder
Laser range finder GLM 100-25 C
Line laser P-Assist*
Original operating instructions
8 hex socket head cap screws, 16 washers, 8
countersunk screws, 8 hex nuts
---
* Only included with product variant SCT 815 S6
---
2.3
2
www.down‐
(1) Base plate
(2) Tool holder for prismatic reflector
(3) Guide tubes
(4) Line laser mount
(5) Line laser P-Assist (only included with product variant
(6) Prismatic reflector
(7) Mount for laser range finder
(8) Laser range finder GLM 100-25 C
---
2.4
Resting surface of the vehicle
• Leveled
• Maximum inclination: 0.1°
• Maximum unevenness: 10 mm
---
SCT 815 S5/S6 resting surface
• The same vertical level as the resting surface of the
• Maximum inclination: 2°
• Maximum unevenness: 5 mm
Order number
1 688 000 368
SCT 815 S5/S6 overview
4
5
3
3
6
7
1
SCT 815 S6)
Prerequisites
vehicle
Order number
1 680 700 315
1 681 038 414
1 688 040 319
1 683 414 021
1 685 350 018
1 680 423 012
1 687 010 642
1 690 381 124
1 689 989 475
1 687 010 613
8
Robert Bosch GmbH
Publicidad
