Publicidad
en | 20 | SCT 815 S5/S6
Should the edges of the prismatic reflector be
misaligned with the centers of the notches, the
mount for the laser ranger finder will be inaccur‐
ately positioned. As a consequence,
SCT 815 S5/S6 cannot be correctly aligned.
5. Insert the laser range finder
shelf (2).
1
2
3
(1) Laser range finder
(2) Vertical shelf
(3) Positioning foot
6. Use the positioning foot (3) to level SCT 815 S5/S6
based on the inclination angle indicator
laser range
finder.
WARNING – severe eye damage from laser beam.
7. Never look directly into the laser source.
8. To test function, hold an object in front of the exit
point of the laser range finder.
9. Switch on the laser range finder.
The laser range finder indicates the current dis‐
tance between the prismatic reflector and the
ground.
CAUTION – risk of crushing when adjusting the
height of the prismatic reflector.
10. Do not place fingers between the tool holder and
the guide tubes.
11. Loosen the knurled screw
til the height of the prismatic reflector can be adjus‐
ted.
1 689 989 475 | 2023-06-28
(1)
into the vertical
of the
(1)
on the tool holder un‐
1
(1) Knurled screw
12. Use the laser range finder to position the prismatic
reflector at the precise specified vehicle-specific
height.
– If the vehicle rests on a lift or leveling surface,
measure the difference in height and add it to the
vehicle-specific height.
13. Use the knurled screw to secure the tool holder.
---
4.5.2
Adjusting the height of the prismatic reflector
using the manufacturer's badge or the front
radar sensor
The height of the prismatic reflector is specified in the
corresponding brief instructions. The height specific to
the vehicle is found in the column with the following
pictogram.
---
On some vehicles, the height of the prismatic re‐
flector depends on the position of the manufac‐
turer's badge or the front radar sensor. For those
vehicles, the height specification column states
where the red laser point must be positioned rel‐
ative to the manufacturer's badge or front radar
sensor.
---
1. Use the corresponding brief instructions.
2. Determine whether the height of the prismatic re‐
flector depends on the position of the manufactur‐
er's badge or front radar sensor.
3. Position the mount for the laser range finder
the prismatic reflector (2).
(1)
on
Robert Bosch GmbH
Publicidad
