Publicidad
Idiomas disponibles
Idiomas disponibles
Changing the speed.
Switch position 1: Low speed
Switch position 2: High speed
Change the speed of the machine only when the
machine is at a complete stop with the speed
switch (3).
Overload protection.
In case of continuous high load over a longer period of
time, the machine is switched off. After a cooling-down
period of approx. 15 minutes, the machine is ready for
operation again.
Working with the machine (Figures 3+4).
Make sure that the protective cover (15) is shut.
Check the gap size of the sanding rest and make sure
that both fastening screws (8) are tightened.
Check the correct adjustment and tight seating of the
eye protection.
Select the speed and switch the machine on.
Position the work piece on the sanding rest and
guide it with both hands.
Extraction device
The machine can be connected via the sleeve (17) to
a dust extraction system.
Repair and customer service.
Repairs may be carried out only by qualified per-
sons in conformity with the valid regulations.
For repairs, we recommend our FEIN customer service
centre, the FEIN authorised service centres and FEIN
agencies.
Carry out the following maintenance daily:
Blow out the ventilation slots (10) at the motor
housing and the marked locations with com-
pressed air (see instruction label).
Remove any deposits from within the housing.
Warranty and liability.
The warranty for the product is valid in accordance with
the legal regulations in the country where it is marketed.
In addition, FEIN also provides a guarantee in accordance
with the FEIN manufacturer's guarantee. For further
details on this, please contact your specialist dealer, your
national FEIN representative, or the FEIN customer serv-
ice centre.
Declaration of conformity.
GRIT declares itself solely responsible for this product
conforming with the relevant provisions given on the last
page of this Instruction Manual.
Original language English/German
Environmental protection, disposal.
Stationary machines should be sorted for environment-
friendly recycling in accordance with national laws.
Noise emission values.
A-weighted emission pres-
sure power level measured
at the workplace L
pA
(re 20 µPa), in decibels
Measuring uncertainty K
in decibels
Measured A-weighted sound
power level L
(re 1 pW),
wA
in decibels
Measuring uncertainty K
in decibels
Operating conditions
Speed [rpm]
Material
Dimension
Wire brush
REMARK: The sum of the measured emission value and
respective measuring inaccuracy represents the upper
limit of the values that can occur during measuring.
Wear ear protection!
Measured values determined in accordance with the cor-
responding product standard (see last page in this
Instruction Manual).
en
Idle
78.5
,
pA
4
87
,
wA
2.5
3000
–
Stainless
–
diametrer
42.4 mm
–
GRIT by
Fein 0.35
11
Grinding
91
4
98
2.5
3000
steel
Pipe,
Publicidad
