Cherubini ORIENS CRC Instrucciones página 48

SMART MODE - motors with mechanical limit switches
This function allows to drive the venetian blind to a favourite middle position. The middle
position is memorized as a descent time starting from the upper limit switch.
SETTING A MIDDLE POSITION
Procedure
1) Press the A+B buttons for at
least 4 s.
The motor will immediately perform a
brief confirmation movement and after
4 s will start again in ascent.
2) Wait for the blind to ascend
completely.
The motor is now running in dead man
mode, enabling the fine adjustment of
the middle position.
3) Confirm the position by
pressing B for 2 s.
As confirmation, the motor performs the
positioning movements automatically
as provided for by the type of tilt
mechanism set.
MOVEMENT TO MIDDLE POSITION
Procedure
1) Give a long (>2 s) stop impulse
with the motor stopped.
The motor initiates with a confirmation
movement, then after 2 s it performs the
positioning movements automatically
as provided for by the type of tilt
mechanism set.
DELETING THE MIDDLE POSITION
A
MIDDLE POSITION
+
B
4 sec
Command sequence
+
A B
4 sec
B
2 sec
Command sequence
B
2 sec
.....
48
.....
Adjustment
.....
Positioning