Cherubini ORIENS CRC Instrucciones página 56

TIMED MODE - motors with mechanical or electronic limit switches
This function allows to drive the venetian blind to a favourite middle position. The middle
position is memorized as a descent time starting from the upper limit switch.
SETTING A MIDDLE POSITION
Procedure
1) Press the A+B buttons for at
least 4 s.
The motor will immediately perform a
brief confirmation movement and after
4 s will start again in ascent.
2) Wait for the blind to ascend
completely.
The motor is now running in dead man
mode, enabling the fine adjustment of
the middle position.
3) Confirm the position by
pressing B for 2 s.
The motor will perform three (3)
confirmation movements.
MOVEMENT TO MIDDLE POSITION
Procedure
1) Raise the blind completely.
With the motor stopped: press B for 2
seconds. The motor lowers the blind for
the time set for the middle position.
DELETING THE MIDDLE POSITION
A
MIDDLE POSITION
+
B
4 sec
Command sequence
+
A B
4 sec
B
2 sec
Command sequence
A
.....
56
.....
Adjustment
B
2 sec Positioning