Publicidad
Idiomas disponibles
Idiomas disponibles
MODALITÀ TEMPORIZZATA - motori con finecorsa elettronico
TIMED MODE - motors with mechanical or electronic limit switches
centralina A510037 o A510039 + Plug & Play, Plug & Play Plus
Before connecting the control unit adjust the limit switch position on the motor. For this
adjustment refer to the motor instruction booklet. After adjustment of the limit switches
connect the control unit.
SETTING THE FIRST REMOTE CONTROL
This operation can only be performed when the control unit is new, or after a total delete
of the memory.
During this step, power up only one control unit at time!
T1: First remote control to be set
+
A
B
T1
After the last confirmation movement, press STOP (B) as soon as the motor starts to move.
During this phase it is not possible to set the motor rotation direction. First, the timed
management settings on the outputs must be set.
BEFORE SENDING A COMMAND TO THE MOTOR ACTIVATE THE TIMED MANAGEMENT ON THE OUTPUTS!
TIMED MANAGEMENT ON THE OUTPUTS
The control unit controls motor movement for a preset time (time-out), that is greater than
the time necessary to reach the limit switch.
Time-out time is factory set at 90 seconds. This value may be changed by following the
directions on page 54 (SETTING TIME-OUT VALUES).
ENABLING TIMED MANAGEMENT
+
B
C
DISABLING TIMED MANAGEMENT
+
B
C
B
T1
B
B
52
B
T1 (2 sec)
+
B
C
2 sec
+
A
B
2 sec
Publicidad
