Cherubini ORIENS CRC Instrucciones página 57

TIMED MODE - motors with mechanical or electronic limit switches
It is possible to run the motor through a switch connected to the control unit with three
wires (up, down and common). The switch must be equipped with mechanical or
electrical interlock, to prevent two commands being sent simultaneously. Furthermore,
the switch must be an unstable pushbutton: releasing it, the switch opens.
L
N
PE
E P 1
FUNCTIONING
Pressing one of the two buttons the motor runs in the desired direction. The motor stops
either by releasing the button or by reaching the time-out.
SLAT OPENING MOVEMENT
UP
press briefly
< 1 sec
The control unit will perform a 2 second descent before opening the slats.
MOVEMENT TO MIDDLE POSITION
UP
press
briefly
< 1 sec
2-BUTTON SWITCH
2 3
release
release
1 - NEUTRAL
2 - PHASE
3 - WIRED SWITCH
PE - EARTH
< 0,5 sec
.....
press briefly
< 1 sec
< 0,5 sec
.....
Press and hold until
reaching the position
57
DOWN
release
DOWN