Cherubini ORIENS CRC Instrucciones página 63

SETTING OF ADDITIONAL REMOTE CONTROLS
Up to 15 remote controls can be set, including the light/wind sensor.
Tn: Already programmed remote control
Tx: Additional remote control
+
A B
Tn
REMOTE CONTROL MEMORY CLEARING
It is possible to delete each memorized remote control individually. When the last one
is deleted the control unit initial condition is restored. The same applies to the single
channels of a multichannel remote control: just select the channel to cancel before
performing the sequence.
Tn: Remote control to be cleared
+
A B
Tn
The full memory clearing can be performed in two ways:
1) WITH THE REMOTE CONTROL
Tn: Already programmed remote control
+
A B
Tn
B
Tn
A
Tn
FULL MEMORY CLEARING
B
Tn
63
B
Tx (2 sec)
B
Tn (2 sec)
+
A B
Tn (4 sec)