Kärcher HDS 13/24 PE Manual Del Usuario página 33

Burner does not start
The water temperature limiter has been
–
triggered.
 Turn off the appliance.
 Press the reset button for the water
temperature limiter in the electrical box.
 Turn on the appliance.
The water temperature limiter has been
–
triggered repeatedly.
 Get the device checked by Customer
Service.
Fuel tank empty
–
 Refill.
Water shortage
–
 Check water supply, check connec-
tions, clean water shortage safeguard.
Fuel pump is defective
–
 Replace fuel pump (Customer Service).
Fuel filter dirty
–
 Change fuel filter.
No ignition spark
–
 If device is in use and no ignition spark
can be seen through the viewing glas,
have device checked by customer serv-
ice.
Set temperature is not achieved
while using hot water
Working pressure/flow rate to high
–
 Reduce working pressure/flow quantity
at the pressure/quantity regulator.
Sooty heating spiral
–
 Have device de-sooted by customer
service.
If malfunction can not be fixed, the de-
vice must be checked by customer serv-
ice.
The warranty terms published by our com-
petent sales company are applicable in
each country. We will repair potential fail-
ures of the appliance within the warranty
period free of charge, provided that such
failure is caused by faulty material or de-
fects in fabrication.
Accessories and Spare Parts
Only use accessories and spare parts
–
which have been approved by the man-
ufacturer. The exclusive use of original
accessories and original spare parts
ensures that the appliance can be oper-
ated safely and trouble free.
At the end of the operating instructions
–
you will find a selected list of spare parts
that are often required.
For additional information about spare
–
parts, please go to the Service section
at www.kaercher.com.
– 13
EN
Warranty
33