Publicidad
Idiomas disponibles
Idiomas disponibles
DRIVE CONFIGURATION
Transducer Application Setup
5. Under Description, choose applicable setting:
•
For level transducer control applications, choose Level.
•
For discharge pressure control applications choose Discharge Pressure.
6. Enter the maximum range for the transducer.
7.
Choose the appropriate units to match the level transducer.
8. Repeat for any additional sensors connected to the sensor input panel.
9. Press the Home button.
Level Transducer Control Configuration
NOTE: Be sure the transducer is set up. Refer to
Auto Mode without Backup Float Configuration
1.
Press the Auto Mode button.
2. Press Auto Mode Setup.
3. Set Pumping Behavior: refer to
4. Set Control Sensor as Analog 1.
5. For Backup Float, select None.
6. For Action if Control Fails, choose what would happen if the control signal is lost.
•
Refer to
"Auto Mode Settings Screen Navigation" on page 16
7.
For Sleep Mode, choose the conditions to put the pump to sleep.
•
Refer to
"Auto Mode Settings Screen Navigation" on page
8. Set Monitoring Behavior as Maintain Level.
9. To start the system, refer to
Auto Mode with a Backup Float Configuration
Normal Operation
1.
Press the Auto Mode button.
2. Press Auto Mode Setup.
3. Set Pumping Behavior:
•
Empty: to empty or draw down the location where the floats are installed.
IMPORTANT: The backup float must be Normally Open for Empty applications.
•
Fill: to fill the location where the floats are installed.
IMPORTANT: The backup float must be Normally Closed for Fill applications.
4. Set Control Sensor as Analog 1.
5. For Backup Float, select Active.
6. Set Float Configuration as Single Float.
7.
For Sleep Mode, choose whether the pump should be allowed to sleep.
•
Refer to
"Auto Mode Settings Screen Navigation" on page
8. Set Monitoring Behavior as Maintain Level.
9. To start the system, refer to
18
"Transducer Application Setup" on page
"Auto Mode Settings Screen Navigation" on page
"Level Transducer Control Startup" on page
Empty Applications
High Level Emergency Mode Engaged
Backup Float
Switch Open
"Level Transducer Control Startup" on page
17.
16.
for details on each option.
16.
26.
High Level Emergency Mode Engaged
Backup Float
Switch Closed
16.
26.
Fill Applications
Normal Operation
Backup Float
Switch Closed
Backup Float
Switch Open
Publicidad
