Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
Hand Mode Operation
Hand Mode Operation
1.
Confirm motor settings are correct by navigating to the SmartPrime screen using the switch on the
front of the panel.
•
Refer to
"Motor Configuration" on page
2. Turn switch on front of ElectricPAK™ VFD panel to Hand mode.
•
The screen above will appear, showing the pump speed and readout for two transducers.
3. Turn the speed potentiometer dial on panel to the desired pump starting speed.
4. Press the START button.
•
The pump will ramp speed up to the level that is set on the dial.
5. To stop the pump, press the STOP button on the front of the panel.
6. Check the motor rotation.
•
If it is running backwards, refer to
28
13.
"Motor Rotation" on page
10.
Publicidad
