Power Control; Energy Save; Power Management - Pioneer PDP-5000EX Manual De Instrucciones

Basic Adjustment Settings

Power Control

Power Control provides convenient functions for power saving.

Energy Save

You may use one of the two Energy Save modes to save power
consumption.
1
Press HOME MENU.
2
Select "Power Control" ( /
3
Select "Energy Save" ( / ).
4
Select "Save 1" or "Save 2" ( / ).
Item Description
Standard Does not decrease the picture brightness.
Save1 Slightly lowers power consumption while
slightly suppressing the brightness drop level.
Save2 Decreases the picture brightness and lowers
power consumption.
5
Press HOME MENU, INPUT 1 to INPUT 6 (INPUT) to exit
the menu.
No Signal off
The Plasma Display will be automatically placed into the
standby mode if no signal is received for 8 minutes.
1
Press HOME MENU.
2
Select "Power Control" ( /
3
Select "No Signal off" ( / ).
4
Select "Enable" ( / ).
Item Description
Disable Does not place the Plasma Display into the
standby mode.
Enable Places the Plasma Display into the standby
mode if no signal is received for 8 minutes.
5
Press HOME MENU, INPUT 1 to INPUT 6 (INPUT) to exit
the menu.
NOTE
• INPUT1 to INPUT6 are enabled. INPUT1 and 4 are disabled,
however, when they have "Signal Type" set to "PC."
• Operation is disabled during display of the HOME MENU.
• A message will be displayed immediately before the Plasma
Display enters standby mode.
then ENTER (ENTER/DISP.)).
then ENTER (ENTER/DISP.).

Power Management

The Plasma Display will be automatically placed into the
standby mode when no signal is received.
1
Press HOME MENU.
2
Select "Power Control" ( /
3
Select "Power Management" ( / ).
4
Select "Enable" ( / ).
Item Description
Disable
No power management
Enable If no input signal is detected for one minute or
more, the unit automatically enters the standby
mode. If a signal is subsequently detected, the
unit automatically turns ON.
5
Press HOME MENU, INPUT 1 to INPUT 6 (INPUT) to exit
the menu.
NOTE
• INPUT1 and INPUT4 only are enabled. However, when
"Signal Type" is set to "AV", they are disabled.
• Operation is disabled during display of the HOME MENU.
then ENTER (ENTER/DISP.)).
09
29
En