Focus; Front Surround; Power Control; Energy Save - Pioneer PDP-5060HD Manual De Instrucciones

Adjustments and Settings
11

FOCUS

This shifts the sound-source direction (sound image) upward
and produces clear sound contours.
1
Press HOME MENU.
2
Select "Sound". ( /
3
Select "FOCUS". ( / )
4
Select the desired parameter. ( / )
Item Description
Deactivates the FOCUS.
Off
(factory default)
On Activates the FOCUS.
5
Press HOME MENU to exit the menu.

Front Surround

This provides three-dimensional sound effects and/or deep,
rich bass.
1
Press HOME MENU.
2
Select "Sound". ( /
3
Select "Front Surround". ( / )
4
Select the desired parameter. ( / )
Item Description
Off Deactivates both the SRS and TruBass.
SRS Reproduces highly effective three-dimensional sound.
Provides deep, rich bass using a new technology.
TruBass
(factory default)
Provides both TruBass and SRS effects.
TruBass + SRS
5
Press HOME MENU to exit the menu.
NOTE
• (WOW) designates a status where the FOCUS is on
and TruBass + SRS has been selected for Front Surround.
• is a trademark of SRS Labs, Inc.
• WOW technology is incorporated under license from SRS
Labs, Inc.
62
En
then ENTER)
then ENTER)

Power Control

Power Control provides convenient functions for saving power.

Energy Save

You may use one of the three Energy Save modes to save power
consumption.
1
Press HOME MENU.
2
Select "Power Control". ( /
3
Select "Energy Save". ( /
4
Select "Save1", "Save2", or "Picture Off". ( /
ENTER)
Item Description
Does not decrease picture brightness.
Standard
Save1 Slightly lowers power consumption while slightly
suppressing the brightness drop level.
Save2 Decreases the picture brightness and lowers power
consumption.
Picture Off Deactivates the screen to save power. To restore the
screen display, press any button other than VOL +/–
and MUTING.
This setting is not memorized by the system.
5
Press HOME MENU to exit the menu.
NOTE
• You can also select this function using the Home menu
when the input source is a PC.

No Signal off (AV mode only)

The system will be automatically placed into the standby mode
if no signal is received for 15 minutes.
1
Press HOME MENU.
2
Select "Power Control". ( /
3
Select "No Signal off". ( /
4
Select "Enable". ( / then ENTER)
Item Description
Does not place the system into the standby mode.
Disable
(factory default)
Places the system into the standby mode if no signal
Enable
is received for 15 minutes.
5
Press HOME MENU to exit the menu.
NOTE
• Five minutes before the system is placed into the standby
mode, a message appears every minute.
• The system may not be placed into the standby mode when
noise signals are present at the Media Receiver after a TV
program finishes.
then ENTER)
then ENTER)
then
then ENTER)
then ENTER)