3M Speedglas ADF G5-01 Instrucciones De Uso página 41

iv. Remove the airduct tube holder (see "Connecting and Disconnecting Breathing Tubes", Fig. 2a – 2c). Place elastic bands over the
welding helmet airduct tube and cable near the welding helmet air deliver flange and near the airduct tube holder. Reattach the airduct
tube holder (Fig. 31c).
NOTE: There is a small loop in the airduct tube holder designed to hold the task light cable. Make sure the cable runs through this loop.
v. Attach the task light to the welding helmet by fitting the tab into the notch on the front of the welding helmet and then pressing the task
light into the mounting piece. Hand tighten the mounting screw on the inside of the welding helmet (Fig. 31d).
2.
1.
4.
5.
Fig. 31c
39
2x
3.
6.