Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLATION
6.8
ELECTRICAL CONNECTIONS
a
The electric connections must be made exclusively
by qualified staff, in compliance with all general and
local safety regulations in force.
Check that the mains power supply voltage and fre-
■
quency match those of the appliance.
The electrical cables MUST NOT come into contact
■
with hot or moving parts, unless they have been insu-
lated and protected with suitable materials.
Only use components with adequate electrical pro-
■
tection rating.
a
Prior to making any electrical connection, discon-
nect the appliance from the power supply.
The manufacturer declines all responsibility for inju-
■
ry to persons and animals or damage to objects due
to failure to earth the appliance or to comply with ap-
plicable regulations.
To make the electrical connections, access the appliance's electrical
devices, as specified in the chapter
CS.SB80.IST_EN_Rev. 2.0_09-23
"Main
components".
Fig. 16
6.8.1 POWER SUPPLY CORD
The appliance is supplied with a power cord that must be plugged
into a power outlet having the same voltage and frequency as the
appliance.
a
The appliance's safety is ensured when it is properly
connected to an efficient earthing system.
When making the electric connection to the mains
■
power supply, include a 6 A – Id 30 Ma residual-cur-
rent device with suitable breaking load.
Make sure that the power supply cord, when in its
■
definitive position, does not come into contact with
hot surfaces.
The power cord should only be plugged in once the
■
appliance has been installed and assembled, and
must remain accessible after the installation.
EN
17
Publicidad
