Publicidad
Idiomas disponibles
Idiomas disponibles
EN
To perform the initial start-up, proceed with the operations described
below:
- connect the appliance to the electrical system using the cable pro-
vided
- position the appliance's "main switch" to "I" (on)
- press the on button
on the remote control or on the control pan-
O
el fitted on the unit.
l
During the first ignition attempts, bad odours may
be released due to the evaporation of the greases
or oily liquids used to manufacture the product and
contained in the paint:
adequately ventilated the room where the appliance
■
is installed
avoid staying in the room for too long, as the vapours
■
emitted could be hazardous to people and animals
during the first few days of us, it is advisable to run
■
the appliance at high power.
8.3
COATING AND FINISHES
To complete the appliance's installation, in addition to that described
above, it may be necessary to also install some accessories, an outer
cladding or other items and finishes.
l
In case of a standard outer cladding and accesso-
ries, follow the instructions provided with them.
l
We recommend performing the steps specified un-
der
Initial
start-up:
before completing the assembly of the cladding
■
once the cladding has been completed and after all
■
the necessary building works have been consolidat-
ed.
9
USE
9.1
LOADING THE FUEL
d
It is forbidden to use any fuel other than pellets.
l
Before proceeding with the operations described be-
low, consult the chapter "Fuel".
20
To load the pellets:
- open the cover of the pellet tank (1)
- introduce the pellets into the tank (2) and close the cover of the
pallet tank.
a
If the cover of the pellet tank is not closed or is
closed incorrectly, the proper oxygenation or opera-
tion of the appliance may not be guaranteed. The ap-
pliance will enter the alarm mode, consult the chap-
ter
"Alarm signals, causes and possible
l
The appliance will generate more noise if the pellet
container is empty. We therefore recommend always
keeping the pellet tank filled to at least half-way.
9.2
CONTROL PANEL ON THE APPLIANCE
The appliance is equipped with a control panel (1) that allows for
managing the appliance's basic functions without the remote control,
that is:
- switching the appliance on or off
- modifying the working power.
1
COMMISSIONING AND USE
1
2
Fig. 17
remedies".
Fig. 18
CS.SB80.IST_EN_Rev. 2.0_09-23
Publicidad
