Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Description
Status
... when pressed
the first time
(1)
INCREASE
button
... programming
... when pressed
the first time
(2)
DECREASE
button
... programming
... when pressed
the first time
... operating
(3)
ON/OFF button
... off
... in alarm block
... in menu/
programming
mode
... when pressed
the first time
(4)
... in menu mode
SET button
... programming
... when pressed
the first time
(5)
... in menu mode
ESC button
... programming
(6)
DISPLAY
22
Action
Allows for modifying
the "SET ROOM" room
temperature.
Modifies/increases the
selected value.
Increases the room
temperature/working power
value.
In "SET AIR" mode, it
modifies the value of
ventilation 2.
Allows for modifying the
"SET OUTPUT" working
power.
Modifies/decreases the
selected value.
Decreases the room
temperature/working power
value.
In "SET AIR" mode, it
modifies the value of
ventilation 1.
Switches on the display.
Switches the appliance
off when pressed for 2
seconds.
Switches the appliance
on when pressed for 2
seconds.
Releases the alarm.
Goes to the previous menu
level without saving the
changes made.
Accesses the user menu.
Goes to the next menu
saving the changes made.
Moves you to the next
sub-menu item, storing the
changes made.
Allows for modifying the
speed of the "SET AIR"
fans.
Goes to the previous menu
saving the changes made.
Moves you to the previous
sub-menu item, storing the
changes made.
9.3.1 DISPLAY
The remote control display shows information on the appliance's op-
erating status.
The display can be switched on by pressing the
The figure below shows the display during normal operating condi-
tions.
23.0° C
1
11:23
2
1 Operating status
2 Current time
3 Room temperature
4 Power set in "SET OUTPUT"
By pressing the
button it is possible to access the MENU and the
s
and
buttons can be used to select the desired item.
+
-
Pressing the
button allows for accessing the selected menu,
s
saving the changes made previously, while the
user back to the previous menu level, memorising also in this case the
changed made previously.
01-STAND-BY
02-CHRONO
03-SET CLOCK
04-LANGUAGE
05-SETTINGS
l
The remote control is equipped with an integrated
room temperature sensor, therefore the room tem-
perature shown on the display is measured by the
remote control itself:
The remote control should thus be positioned in an
■
optimal point of the room where the appliance is in-
stalled.
COMMISSIONING AND USE
button.
O
3
OFF
3
4
Fig. 21
button takes the
E
MENU
Fig. 22
CS.SB80.IST_EN_Rev. 2.0_09-23
Publicidad
