Publicidad
Idiomas disponibles
Idiomas disponibles
COMMISSIONING AND USE
9.4
IGNITION CYCLE
9.4.1 PRELIMINARY CHECKS
l
Verify that the pellet tank is not empty. If it is, fill it
and perform the operations described in the para-
graph
Loading the
fuel.
a
Before switching on the appliance, make sure that
the brazier is clean and that there are no pellets in-
side it. If there are, the brazier must be emptied and
cleaned.
We recommend using good-quality pellets so as to
■
avoid impairing the appliance's operation. Damages
caused by poor-quality pellets shall not be covered
by the warranty.
Do not pour pellets manually into the brazier.
■
a
Before switching on the appliance after it switched
off due to an empty tank and auger condition, it is ad-
visable to perform a pre-loading cycle by accessing
the
INITIAL LOAD
menu.
9.4.2 IGNITION
Prolonged pressing of the
O
control panel fitted on the unit, causes the appliance to start up.
The ignition cycle can last maximum 20/25 minutes maximum and is
divided into five phases, shown below.
Display
Phase
Meaning
message
First
CHECK UP
Brazier cleaning cycle
Pre-loading of the brazier
with pellets (continuous
LOAD
pellet loading) to fill the
Second
PELLET
brazier sufficiently and
ensure that the appliance
switches on correctly
Stand-by for flame
ignition after pre-
Third
FIRE WAIT
loading (pellet loading is
suspended)
FIRE WAIT
Pellet loading in the
Fourth
/ LOAD
brazier (the pellets are
PELLET
loaded intermittently)
Flame stabilisation to
allow uniform ignition of
FLAME
Fifth
all pellets that were not
LIGHT
burned in the previous
phases.
CS.SB80.IST_EN_Rev. 2.0_09-23
button on the remote control, or on the
Duration
Roughly 30
seconds
Roughly 4
minutes
Roughly 4
minutes
Not ascer-
tainable
Roughly 8
minutes
At the end of the ignition cycle, the appliance enters the work mode at
the power set under "SET OUTPUT".
l
If the ignition fails, the display will show the "FAILED
IGNITION" alarm. The alarm could also occur if the
brazier or ignition device tube are dirty. In this case,
clean the brazier and the ignition device tube and re-
start the appliance.
It is possible to book the switch-off (prolonged press-
■
ing of the
button) during the ignition phases. The
O
"WAITING OFF" message indicates that the booking
has been made. The appliance will only switch off at
the end of the ignition cycle.
l
Any noises heard during the operating phases could
be due to the expansion of the metal plates making
up the boiler body. These noises can be more fre-
quent during the appliance ignition and switch-off
phases and must not be regarded as a manufactur-
ing defect.
Any perceived smell of smoke (especially during the
■
ignition phase) should not be regarded as a manu-
facturing defect.
a
During the ignition phase and normal operation of
the appliance, keep at a safe distance from the appli-
ance and do not remain standing in front of it. Some
parts of the product (door, handle, adjusters, ceram-
ic parts) may reach very high temperatures. Be very
careful: adopt the appropriate precautions and wear
adequate personal protective equipment, especially
if there are children, elderly and disabled people and
animals.
During the ignition phase and normal operation of
■
the appliance, the door must ALWAYS remain closed
and the glass must be intact.
Keep any flammable products (e.g. wooden furni-
■
ture, tapestries, rugs, fabrics, clothing, ornaments,
flammable liquids, etc.) far away from the appliance.
EN
27
Publicidad
