Publicidad
Idiomas disponibles
Idiomas disponibles
MAINTENANCE
12 WIRING DIAGRAMS
The wiring diagrams can be viewed by scanning the following QR
Code from your smartphone.
https://docs.klover.it/it/guide/help/cs-sche-r023-2_m-1
13 PARAMETER TABLES
The parameter tables can be viewed by scanning the following QR
Code from your smartphone.
https://docs.klover.it/it/guide/help/cs-s80-par-1
14 STANDARD WARRANTY CONDITIONS
The standard warranty conditions can be viewed by scanning the fol-
lowing QR Code from your smartphone.
https://docs.klover.it/it/guide/help/cs-cgc-1
15 INACTIVITY OF THE PRODUCT
At the end of every season, or before a long period of inactivity of the
product, it is necessary to:
- remove all the pellets left in the tank, as explained in the chapter "
Cleaning of the pellet
tank"
- perform all the cleaning and maintenance operations specified in
the paragraph "Maintenance"
CS.SB80.IST_EN_Rev. 2.0_09-23
- entrust specialised and qualified personnel to check, clean and ser-
vice the product and the entire system (the fume exhaust pipes,
combustion air intake pipes, the external air intake, any hot air
ducts, etc.)
- if the appliance is equipped with a remote control, remove the bat-
teries from the latter to prevent possible oxidation
- disconnect the appliance and/or any accessories installed from the
power supply.
l
Excessive humidity and excessively long periods of
non-use may cause rust to form on certain uncoated
parts inside the product.
This is a natural occurrence that does not hamper
■
the efficiency and durability of the products, and
must not be regarded as a defect.
l
After the product has not been used for a long time,
the materials may expand again and smelly vapours
may recur. Consult the paragraph
16 END-OF-LIFE DISPOSAL
The product must be disposed of exclusively by the owner, who is
responsible thereof and who must act in conformity to the regulations
in force concerning safety and environmental protection.
Contact the competent authorities for information on the relevant
local regulations.
Entrust a qualified technician to permanently decommission the
product.
Before dismantling the product:
- disconnect the power supply (for appliances powered electrically)
- put all the system's components and connections in safe condi-
tions.
When this symbol appears on the appliance or
accessories, or on their packaging or documen-
tation, it means that the appliance, accessories
batteries/accumulators and relative electrical
and electronic components must NOT be regard-
ed and disposed of as normal household waste
but must be delivered to an appropriate waste
collection facility for the recycling of waste elec-
trical and electronic equipment.
Incorrect disposal can be harmful to human
health and to the environment.
It is possible to ask the dealer to collect waste
electrical and electronic equipment under the
conditions and with the procedures specified in
the national regulations that transpose Directive
2012/19/EU (for Italy see Legislative Decree
49/2014).
Contact the competent authorities for informa-
tion on the relevant local regulations.
EN
"Initial
start-up".
39
Publicidad
