IPC Gansow T10 Manual De Instrucciones página 23

After cleaning mats or carpets, you will have
to clean the machine, especially its container,
its rear plating (2 FIG.13) and the suction outlet
(1 FIG.13).
Check the rubber wiper, located in the suction outlet, for
wear and if necessary replace it.
Remove the washing water tank and the partition.
Remove the roller as described below.
Loosen the screw.
Remove the suction unit (1 FIG.13) and replace the rubber
accessory.
Refit all parts removed.
To clean the machine, use a sponge dampened
with alcohol and water. Do not spray water onto
it.
To replace the belts, contact our technical
assistance department.
13.3 REPLACING THE FUSE (FIG.14)
To replace the fuse:
Raise the cover (A).
Loosen the three guard fixing screws (B).
Remove the fuse (C) and replace it. ( 4 A )
Reassemble the parts removed by following the above
instructions in reverse order.
FIG.13
ENGLISH (Translation of original instructions)
FIG.14
Pag. 8