Connection To A Coffee Machine (Fig. 6 - 7 Optional); Connecting An Executive Coffee Vending Machine To A Baby Fas Vending Machine - FAS BABY Manual De Instrucciones

BABY FAS – Issue 04
7.6

CONNECTION TO A COFFEE MACHINE (FIG. 6 - 7 OPTIONAL)

7.6.1 CONNECTING AN EXECUTIVE COFFEE VENDING MACHINE TO A BABY FAS VENDING
MACHINE
Do not fasten the cable to the pipes of the condenser. The high temperatures of
the condenser pipes can ruin the electric cable. Fasten the cable with bands to
the wall of the cabinet.
The function of the Executive/MDB slave coffee machine cable (code no. 310110) is to connect one vending
machine to another. The connecting cable is connected to the connector J4B located on the electric panel at
the rear of the vending machine (see FIG. 6).
Coffee
Slave, senza gettoniera
Slave, without coin system
WARNING: The coin mechanism must only be connected/disconnected with the
machine switched off.
Selecting the coin mechanism operating mode (see also command 69 in the manual ):
•
Use command 69 to select the coin mechanism operating mode and type (the parameter can be one of
the following values : 0, 1, 2, 4 or 5).
If the value is set at "0" or "1" (EXECUTIVE system) the machine offers the option of selecting to enable or
disable the connection of a slave machine, if available, with executive protocol. The two available options
appear alternately on the display by pressing any key on the keyboard except "B". Confirm the selection by
pressing "B" while the required option is displayed .
FAS INTERNATIONAL S.p.A. Via Lago di Vico, 60 SCHIO (VI) – tel. +39 0445 502011 – fax +39 0445 502010 - e-mail: info@fas.it
Connessione Executive
master / slave
J4A
J4B
310107
Master / slave
Executive link
FIG. 6
MDB
J4
Master
15
E
N
G
L
I
S
H