Procedure For Changing The Trays From A Large Space To Two Little Spaces (Fig. 13); Procedure For Changing The Trays From Two Little Spaces To One Large Space (Fig. 13) - FAS BABY Manual De Instrucciones

BABY FAS – Issue 04
9.4 PROCEDURE FOR CHANGING THE TRAYS FROM A LARGE SPACE TO TWO LITTLE SPACES
(FIG. 13)
1) Open the main door.
2) Switch the main switch off.
3) Take out the tray you wish to alter.
N.B. When removing the tray, ensure that the wire does not slip into the space
between the tray and the wall and that it is not stretched excessively.
4) Take out the group motor + spiral ref.1.
5) Take out the tray ref.3.
6) Replace the spiral with large diameter with one with small diameter.
7) Insert the group motor + spiral with small diameter in the left slot of the support ref.4.
8) Insert the new group motor + spiral with small diameter in the right slot connecting it to
the wiring placed on the tray .
9) Add the new divider blades between the two spirals.
10) Insert the new price labels and the selections.
11) Insert the altered tray and switch the connector on.
12) Programme the new selections to the wished selling price.
13) Check the altered selections to make sure that they are working.
When taking the tray out or inserting it, especially if it is full of items, handle it with
care. Tilt it appropriately and insert the runners in the guides correctly (see figure)
without forcing, otherwise there is a risk of damaging the front runners and/or the slide
guides, especially when these actions are repeated.
9.5 PROCEDURE FOR CHANGING THE TRAYS FROM TWO LITTLE SPACES TO ONE LARGE
SPACE (FIG. 13)
1) Open the main door.
2) Switch the main switch off.
3) Take out the tray you wish to alter.
N.B. When removing the tray, ensure that the wire does not slip into the space
between the tray and the wall and that it is not stretched excessively.
4) Take out the group motor + spiral ref.1.
5) Take one of the two groups apart. Replace on the other one the spiral with small diametr
with a spiral with large diameter.
6) Take out the divider blade ref.2.
7) Insert the tray ref.3.
8) Insert the group motor + spiral with large diameter in the middle slot of the support ref.4.
9) Insert the new price labels and the selections.
10) Insert the altered tray and switch the connector on.
11) Programme the new selections to the wished selling price.
NOTE: By the selections with large spaces the number of selections will be odd.
Example: If selections A1 and A2 will be changed to a single compartment, the
selection becomes A1.
12) Check the altered selections to make sure that they are working.
FAS INTERNATIONAL S.p.A. Via Lago di Vico, 60 SCHIO (VI) – tel. +39 0445 502011 – fax +39 0445 502010 - e-mail: info@fas.it
FIG. 13
37
E
N
G
L
I
S
H