Use Of Payment Systems Mdb - FAS BABY Manual De Instrucciones

32
8.6

USE OF PAYMENT SYSTEMS MDB

Installation: The coin mechanism MDB has to be connected to the connector J4 of the control card (see
figure). The command 69 has to be programmed to value 5, then turn off the machine for some seconds.
By putting it on again the machine and the coin mechanism will comunicate correctly.
There are the following additional commands for the use of these payment systems:
Command 27
Command 28
E
Command 29
N
Command 30
G
Command 31
L
Command 32
I
Command 33
S
Command 34
H
Command 35
Command 36
Command 37
Command 38
Command 39
Command 27 Setting the signal for payment system out of order:
If the command is set at 1, when the connection with the MBD payment system is interrupted the vending
machine goes out of order and the message appears on the display; if the command is set at 0 (zero), the
option is disabled. The default setting is 0.
Command 28 Select change giving tube content counter:
This command allows the user to select whether to use the counters corresponding to the content of the coin
mechanism change giving tube or use only the counters inside the machine. If the command is set at 1 at
each power-up the counters inside the machine which correspond to the content of the change giving tubes
are updated with the values transmitted by the coin mechanism. If, on the other hand, the command is set at
0 the values transmitted by the coin mechanism are ignored.
Command 29 Cashless credit cannot be displayed:
This command allows the user to prevent or enable display of credit from the MDB cashless device (key or
card reader). If the command is set at 1 the credit corresponding to the cashless device is not displayed,
whereas if the command is set at 0 the machine also displays the credit available on the cashless device.
Command 30 Purchase obligation before return:
By setting this command to 1 the customer is obliged to purchase before receiving back the return. This is to
avoid to use the coin mechanism as a coin-changer. If the purchase fails to happen, the return will be given
out.
Command 31 Setting max key or cash credit accepted:
The max credit accepted by the coin mechanism by either key/card or cash is set, and if this amount is
exceeded acceptance of further coins or notes is blocked.
1. Programming mode, display views............................................................................................. Command 00
2. Key in 31 and press B, display views ....................................................................................... Maxkey
3. Key in amount required (key max credit) and press B.
4. Display views .......................................................................................................................... Maxcash
5. Key in required amount (cash max credit) and press B.
FAS INTERNATIONAL S.p.A. Via Lago di Vico, 60 SCHIO (VI) – tel. +39 0445 502011 – fax +39 0445 502010 - e-mail: info@fas.it
WARNING: The coin mechanism must only be connected/disconnected with the
machine switched off.
Setting the signal for payment system out of order.
Select change giving tube content counter.
Cashless credit cannot be displayed.
Purchase obligation before return.
Setting max key or cash credit accepted.
Minimum coin level in the tubes.
Inhibits single coins.
Inhibits coins during exact amount.
Resetting coin meters in change giving tubes.
Condition: exact amount (no coins available for change).
Inhibits note validator during exact amount.
Emptying of change giving tubes.
Filling in of the change giving tubes.
To set the following option ONLY, enter the "programming mode" and when the
message "command 00" appears on the display press the "test" button again for a
further 3 seconds, after which the buzzer will sound again for a few seconds, and
access to the second level of the menu is obtained. The message "Command 00" will
appear again. To quit the programming mode press the "A" key .
BABY FAS – Issue 04
xxxx
xxxx