Programming Procedure; Check Selections - FAS BABY Manual De Instrucciones

BABY FAS – Issue 04
When the machine is switched on the machine will start a self-configuration procedure that consist in
checking the No. of spirals in every tray. In this phase the message TEST 12 will appear for some seconds
on the display and after this the machine can be put into service.
When the machine is switched on for the first time the message "INIT" and then "memory cleared" will
appear on the display. This message indicates that the memory has no stored data or that the data in
memory are corrupted. The machine is in the same condition as it is after the "erase memory" command has
been executed or the memory has failed.
Pressing the push-button "TEST" mounted on the card inside the coin mechanism, the memory will be
automatically reset to its pre-defined values listed in the programming instructions.
Attention: if the button is released before time the machine will enter "check selections" mode described
under. To exit this mode press again the button and then repeat the process to enter in programming mode.
8.1

CHECK SELECTIONS

It is also possible to carry out a function test of the machine by pressing the pushbutton "TEST" placed on
the main card. The message "SELECTIONS OK" will appear on the display. As an alternative an indication
(ex. 12, 14...) could appear to indicate that an irregularity has taken place during the functioning and the
spirals indicated are out of service. Carry out the selection shown on the display to reset. If a working
mistake happens during the test, the tag of the spiral or module will stay on the display; otherwise the test
will go on to the next out-of-work spiral. If all the selections are all right the corresponding message will
appear on the display. It is possible to test all the selections typing in the corresponding tag. After having
finished the test press again the push-button test on the main card to go back to normal working.
N.B.: To avoid errors the machine returns automatically to normal work after about 1 minute from the
access to test mode, during which no operation is carried out.
If during the test or the reset there should happen some errors, it means that the anomaly is not occasional
but could result from the breakage of some parts and a technical intervention is required.
FAS INTERNATIONAL S.p.A. Via Lago di Vico, 60 SCHIO (VI) – tel. +39 0445 502011 – fax +39 0445 502010 - e-mail: info@fas.it
8

PROGRAMMING PROCEDURE

Once the installation is completed, open the door
FIG. 2 and hold down the "TEST" button on the
board for at least 3 sec until the buzzer starts to emit
a continuous sound. This indicates that the machine
is
Command 00 appear on the display. It is possible to
read sales data and to set machine operating
parameters from this level. To Enter a Command,
press the corresponding command on the selection
panel and press the button B to confirm the
selection.
When a submenu is accessed an identification
message appears on the display. Push-button B is
used also to confirm the inserted board-data and to
store them. In this case on the display appears for a
few seconds the message "OK".
To leave programming mode or to pass from a
submenu to the main menu press A.
in programming mode
19
and the message
E
N
G
L
I
S
H