Publicidad
Idiomas disponibles
Idiomas disponibles
Device Usage (Linux Environment)
Using D500S commands
About D500S
IkD500S_about
(About D500S, Figure10.3)
This command will populate information about the
D500S such as:
•
Vendor
•
Product
•
D500S Serial number
•
Firmware version
•
Software version
D500S login
ikD500S_login
Once the D500S has been initialized on a supported Windows or macOS system, you can access the secure data
partition by logging into the device using the D500S password you created.
To do so, follow these steps:
1. Open a 'Terminal' application window.
2. Type the following command at the terminal prompt: cd /media/ubuntu/IRONKEY/linux/linux64
3. With the command prompt now at /media/ubuntu/IRONKEY/linux/linux64$, type the following
command to login to the device: ./ikD500S_login* and press ENTER. (Note: Commands and folder
names are case-sensitive, and syntax must be exact. Also, some distributions may require you to input
your username i.e., "ubuntu" in this example.)
4. After a successful login, the secure data volume will open on your desktop, and you can proceed to use the
D500S (more information on login behavior continued on next page)
*Note: Certain distributions of Linux will require super-user (root) privileges in order to execute the D500S
commands properly in the terminal application window.
Figure 10.3 – ikD500S_about (About IronKey D500S)
39
Publicidad
