Publicidad
Idiomas disponibles
Idiomas disponibles
Device Usage (Linux Environment)
D500S login (continued)
Incorrect login password behavior
During the login process, if an incorrect
password is entered, you will be given
another opportunity to enter the password.
However, there is a built-in security feature
that tracks the number of failed login
attempts. If this number reaches the pre-
configured value of 10 failed attempts for
either the Admin or User logins, the behavior
will be as follows:
Admin/User passwords enabled
•
User Login: User lockout, login as
Admin required. (Figure 10.6) Note:
The User password can be reset by
the Admin login on a supported
Windows or macOS system.
•
Admin Login: Drive crypto-erase, all
data is lost forever. Device reset
required. (Figure 10.7)
User-Only Mode (admin/User not enabled)
•
User Login: Drive crypto-erase, all
data is lost forever. Device reset
required. Figure 10.7)
D500S Logout
IkD500S_logout (lock device)
When you are finished using the D500S, log
out of the device and secure your data. To do
so, follow the same steps referenced on page
39 and use the following command logout of
the device properly: ./ikD500S_logout and
press ENTER (Note: Commands and folder
names are case-sensitive and syntax must be
exact. (Figure 10.8)
Figure 10.6- User login Lockout, Admin/user Passwords enabled
Figure 10.7- Maximum number of attempts reached (Drive Reset)
Figure 10.8- D500S Logout
41
Publicidad
