Publicidad
Idiomas disponibles
Idiomas disponibles
Device Usage (Linux Environment)
D500S Device Reset
ikD500S_resetdevice
As mentioned previously on page 41, In
the event the User/Admin passwords
are forgotten, the Reset Device
command can be used to reset the drive
so it can be used again. This process will
allow you to create a new password,
but in order to protect the privacy of
your data, the D500S will crypto-erase
the drive format the secure data
partition. This means that all of your
data will be lost.
To use the Reset Device command,
follow the same steps referenced on
Page 39 and use the following
command logout of the device properly:
./ikD500S_resetdevice and press ENTER
(Note: Commands and folder names are
case-sensitive and syntax must be exact.
(Figure 10.9)
Once the Reset Device command has
been used, you will be prompted to
create a new Complex password that
must contain:
• 8 - 16 Characters long and contain at
least (3) of the following criteria
options:
-UPPER CASE
-lower case
-numeric
-Special Characters (!,$,etc.)
(Figure 10.10)
Note: The Reset Device command will
initialize the drive in User-Only mode
(Single password, single user). To
enable Admin/User login password
profiles, the D500S will need to be set
up on a supported Windows or macOS
system to access that option.
Figure 10.9- Reset Device command
Figure 10.10- Reset device command, password creation
42
Publicidad
