Publicidad
Idiomas disponibles
Idiomas disponibles
Recording on MDs
5 Press STANDBY.
The CD player pauses for playing and the deck
pauses for recording.
6
Press START.
The deck starts recording and the CD player starts
playback.
The track number and elapsed recording time of
the track appear in the display.
If the CD player does not start playing
Some CD player models may not respond when you
press START on the remote of the deck. Press fll on the
remote of the CD player instead.
7
Press STOP to stop synchro-recording.
To pause recording
Press STANDBY or CD PLAYER U1.
To restart recording, press START or CD PLAYER U5.
A new track number is marked each time you pause
recording.
Note
When using the supplied remote for synchro-recording, set
the mode selector on the CD player to CD1.
cor You can use the remote of the CD player during
synchro-recording
When you press Mf, the CD player stops and the deck
pauses for recording.
When you press 88, the CD player pauses and the deck
pauses for recording.
To restart synchro-recording, press >.
¢ You can change CDs during synchro-recording
.
Do,the following steps instead of Step 7 above.
1 Press M on the remote of the CD player.
The deck pauses for recording.
2 Change the CD.
3 Press > on the remote of the CD player.
Synchro-recording restarts.
CD player
Using the procedure for synchro-recording with a Sony
CD player, you can do synchro-recording with a Sony
video CD player also.
To select the video CD player, press button number 2
while pressing down the POWER button before starting
the procedure.
To select the CD player again, press button number 1
while pressing down the POWER button.
The deck is factory set to a CD player for synchro-
recording.
a You can check the remaining recordable time on the
MD
Press DISPLAY (see page 17).
Publicidad
