Sony MDS-S39 Manual De Instrucciones página 30

30"
Editing Recorded MDs
7 Press YES.
This completes the labeling procedure and the
title appears on the left side of the display.
To cancel labeling
Press @.
Note wat
You cannot label a track or an MD while you are recording
over an existing track.
Labeling tracks and MDs with the remote [J]
Alphabet/number
buttons
1 Press NAME repeatedly until a flashing cursor
appears in the display, then do the following:
To label Make sure that the deck is
A track Playing, pausing, recording the track
to be labeled, or stopped after
locating the track to be labeled
An MD Stopped with no track number
appearing in the display
2 Select the character type as follows:
SEE
To select Press
Uppercase letters CHAR repeatedly until "Selected
ABC" appears in the display
Lowercase letters CHAR repeatedly until "Selected
abc" appears in the display
Numbers NUM repeatedly until "Selected
123" appears in the display
3 Enter one character at a time.
After you enter a character, the cursor shifts
rightward and waits for the input of the next
character.
If you entered the wrong character
Press <<¢ or >> until the character to be corrected
starts flashing.
5 Press NAME again.
The entered title appears on the left side of the
display window after the label has been recorded.
To cancel labeling
Press @.
Changing an existing title [7]
1° Press NAME, then do the following:
To change Make sure that the deck is
A track title Playing, pausing the track whose
title is to be changed, or stopped
after locating the track whose title is
to be changed
A disc name Stopped with no track number
appearing in the display
2 Keep pressing CLEAR (or EDIT/NO on the deck)
until the current title is erased.
3 Enter the new title.
Do Steps 3 to 6 of "Labeling Recordings" on page
29, or Steps 2 to 4 of "Labeling tracks and MDs
with the remote" on this page.
4 Press NAME.