HURNER HST 300 Pricon 2.0 Manual De Instrucciones página 42

set-up, this input is required before the fitting code can
be entered.
Use the arrow keys ñ, ò to select from "sunny," "dry,"
"rain," "wind," "tent," and "heating." Press the START/
SET key to confirm your selection. The selection is saved
to memory and will appear in the printed welding report.
6.6 Entering Data on the Jointed Components
According to the same procedure as used for entering
the fitting traceability code (see Sect. 6.4), prior to the
welding proper the ISO-compliant codes of the pipes to
be welded, their length as well as the installing company
can be entered for inclusion in the welding reports. For
this to be possible, they have to have been enabled in the
configuration menu.
6.7 Recording the Geo-data of the Planned Joint
Provided that geo-data recording is enabled in the con-
figuration menu (see Sect. 10.2), the geographic coordi-
nates can be recorded, if the GPS module is on, as soon as
Display 12 shows on the screen.
Wait at least 1 minute from switching the GPS
module on to the actual recording of the geo-data,
Important or the GPS module will throw a not-ready error.
During the first minute after switching the GPS module
on the following messages may appear on the screen: "No
signal," "GPS module failed," "GPS Error, Restarting," and
"GPS Module not Ready." These are no errors during the
starting minute of initialization right after switching on.
If they appear after this time, they have to be considered
actual error messages. In this case, the restart after a GPS
(signal processing) error will be performed by the module
itself, without any user action. The Not Ready message
disappears automatically, too, as soon as the module is
ready for recording.
The geo-data are recorded after you selected "Yes" in
Display 12 using the ñ and ò arrow keys and confirmed
this selection by pressing the START/SET key. A message
confirms that the data have been recorded. The recorded
data then show on the screen (see Display 13). A second
screen is used to display additional information on the
precision at the time of recording. To switch back and forth
between both geo-data screens, press the ð key.
If it is likely that no satisfactorily precise position will be
16
EN
HÜRNER HST 300 Pricon 2.0 User's Manual
H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
Record Geo-Data
>Yes
No
Current Position
050·38,4873'N
008·59,4141'E
Sat:7
Version January 2018
Display 12
Display 13