HURNER HST 300 Pricon 2.0 Manual De Instrucciones página 49

H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
10.1.2 Setting the Clock
When the "Set Clock" sub-menu was selected, the screen
changes and the display reproduced in Display 23 appears.
The time of day and the date can be set using the keypad.
The portions "Hour," "Minute," "Day," "Month," and
"Year" are set separately. Press the START/SET key to con-
firm your settings.
10.1.3 Setting the Buzzer Volume
When the "Set Volume" sub-menu was selected, the screen
changes and the display reproduced in Display 24 appears.
The buzzer can also be heard. Turn the buzzer volume up
or down to the desired value using the ï, ð arrow keys
(from 0 to 100) and confirm your setting by pressing the
START/SET key.
10.2 Understanding the "Recording" Sub-menu
"Welder Code on" means that the welder identification
code has to be entered as set with "Welder Code Op-
tions," "off," that this is impossible.
"Commission Number on" means that the commission
number (job number) will have to be entered or con-
firmed before every new welding, "off" that the user
is not prompted to enter it.
"Joint Number on" means that the unit assigns an auto-
matically incremented joint number to every welding
operation belonging to a commission already known,
and displays this number on the screen next to the
report number, "off" that no joint numbers will be
assigned at all.
"Additional Data on" means that the additional data will
have to be entered or confirmed before every new
welding, "off" that the user is not prompted to enter
them.
"Fitting Code on" means that the second, so-called trace-
ability code of the electrofusion fitting has to be
entered before every welding, "off," that this is not
possible.
"Pipe Codes on" means that the codes of both pipes/
components (ISO-compliant welding and treaceability
codes) have to be entered before every welding, "off,"
that this is not possible.
"Pipe Length on" means that the length of both pipes/
components has to be entered before every welding,
"off," that this is not possible.
"Weather Conditions on" means that the weather has to
be selected in a list before every welding, "off," that
this is not possible.
Version January 2018 HÜRNER HST 300 Pricon 2.0 User's Manual
Date/Time
21.06.13 14:28
Display 23
Buzzer Volume
< ------20-------- >
Display 24
Data Recording
Welder Code on
>Commission No. on
Joint No. off
Display 25
Data Recording
Additional Data on
>Fitting Code on
Pipe Codes on
Display 26
Data Recording
Pipe Length on
>Weather Cond. on
Geo-data off
Display 27
EN
23