HURNER HST 300 Pricon 2.0 Manual De Instrucciones página 47

H Ü R N E R S c h w e i s s t e c h n i k G m b H
Nieder-Ohmener Str. 26
35325 Mücke, Germany
9.3 Overheating Switch
The welding process aborts if the temperature of the weld-
ing unit is too high. The overheating circuit breaker for the
welder stops the welding process if the temperature read-
ing is too high and the remaining welding time is longer
than 800 seconds. The display and the welding report will
show an "Overheated" message.
9.4 Indication of Power Supply Failure at the Last
Welding
The message "Power Supply Failure Last Welding" indicates
that the previous welding aborted because of a power
supply failure. The reason may be too weak a generator
or too long or too thin an extension cable, or a tripped
cut-out in the mounting box. The next welding operation
is still possible after acknowledging the message by press-
ing the STOP/RESET key.
10 Configuring the Welding Unit
With the operator identity card, the welding unit can be
reconfigured. When the MENU key is pressed, the "Enter
Menu Code" message appears on the screen. After the
code was read from the operator card, the selection menu
in Display 17 shows.
At "Settings," the parameters related to the welding unit
itself and its operation can be set. At "Recording," the
traceability data that have to or need not be recorded
and written into the reports can be enabled or disabled.
The desired sub-menu is selected using the ñ and ò arrow
keys. Then to access that sub-menu, press the MENU key.
In both parts of the configuration menu, use the ñ and
ò arrow keys to select the desired set-up option. Use the
ð arrow key to toggle between "on" and "off" for that
set-up option.
If a "M" is shown next to a set-up option, this indicates that
a sub-menu is accessible here by pressing the MENU key.
Press the START/SET key to confirm the set-up and save it
to memory.
10.1 Understanding the "Settings" Sub-menu
"AutoWeld on" means that the AutoWeld feature for the
easy definition of welding parameters (see Sect. 5.5)
can be used, "off," that the feature is not available.
Version January 2018 HÜRNER HST 300 Pricon 2.0 User's Manual
>Settings -M-
Recording -M-
Display 17
*** SET-UP MENU ***
>AutoWeld on
Check Cd Expiry off
Memory Control on
Display 18
EN
21